THE DYNAMIC ROUTING PROTOCOL FOR ITS CAMPUS NETWORK

Qualified Writers
Rated 4.9/5 based on 2480 reviews

100% Plagiarism Free & Custom Written - Tailored to Your Instructions

Question 1 (20 marks)

 

USQ College uses OSPF as the dynamic routing protocol for its campus network. The network is not connected to any ISP and is isolated from the Internet.

 

The in-house network administrator insisted that the existing authentication process for OSPF is not efficient. So he assigned you to re-programmed OSPF such that the authentication process will apply MD5 to a message and the output will be sent to destination as cipher text. The receiver will apply MD5 and get back the original message.

 

The network administrator knows that AES is one of the best encryption algorithms we can use. As the next phase of improving the security, he planned to switch from MD5 to AES for OSPF authentication. You are assigned to be in charge of this switching over as your next task.

 

  1. Will you accept the first task or reject it? Explain your reasons for accepting or rejecting the task.

 

  1. Will you accept the second task or reject it? Explain your reasons for accepting or rejecting the task.

 

  1. The network administrator is planning ahead to connect the campus network to an ISP. Assume that the OSPF to be used is the standard version, not the modified version. List and explain the routes to be installed in the boundary router and the ISP router.

 

  1. Assuming the ISP router has an IPv4 address of 200.200.200.1 and the LAN gateway router has an IPv4 address of 201.201.201.1. List the required Cisco commands to install the routes.

 

  1. How can transfer the route to the ISP to other routers within the campus LAN?

 

Question 2 (10 marks)

 

Floor plan of the Wolfgang Concern Hall:

35 m

 

 

 

 

25 m

 

 

 

 

 

50 m

 

 

 

 

 

 

70 m

 

You are going to implement a wireless network to the Wolfgang Concern Hall using access points with an effective range of 14 meters.

 

  1. What is the minimum number of access point do you need?

 

  1. Show

 

In a diagram, show how the concern hall was covered by the wireless range of access points. The diagram should also show the coverage of individual access points.

 

Your calculation,

 

The data you use for the calculation, and any assumptions you made.

 

  1. Which type of access point (independent, controller based, cluster, cloud) will you use? Explain the reason for your choice.

 

Question 3 (20 marks)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Download Q3.pkt.

 

Q3.pkt simulates the switched network of ANZ College.

 

Assume all links are of the same cost.

The top two switches are S1 and S5.

 

  1. Why STP allows links L1 and L2 both to be active?

 

  1. Which switch is the root switch?

 

  1. What is the path assigned by STP:

 

    1. From S4 to root switch?

 

Explain why other paths are blocked.

 

List the root port(s), designated ports and non-designated ports along the path from S4 to root switch.

 

    1. From S5 to root switch?

 

Explain why other paths are blocked.

 

List the root port(s), designated ports and non-designated ports along the path from S4 to root switch.

 

  1. Explain the port status for the ports of link L7 and link L8.

 

Question 4 (20 marks)

 

Aussie College uses EIGRP as the dynamic routing protocol for its campus network. The network is connected to an ISP using a single router R1.

 

  1. The in-house network administrator is not happy when R1 fails, all users will be disconnected from the Internet. What would you suggest to improve the situation? Justify your suggestion.

 

  1. The Aussie College LAN uses Cisco switches and is running STP. What would suggest to improve the convergence speed of the LAN network? Justify your suggestion.

 

  1. The network administrator assigns you to implement redundancy for the network. Provide an implementation plan with supporting reasons to the network administrator.

 

Part B (30 marks)

 

Question B1 - 3_2.3.1 Packet Tracer - Configuring PVST

 

Submit QB1.pka.

 

Question B2 - 3_2.3.2 Packet Tracer - Configuring Rapid PVST

 

Submit QB2.pka.

 

Question B3 - 3_3.2.1 Packet Tracer - Configuring EtherChannel

 

Submit QB3.pka.

 

Question B4 - 3_4.4.2 Packet Tracer - Configuring Wireless LAN Access

 

Submit QB4.pka.

 

Question B5 - 3_5.2.2 Packet Tracer - Troubleshooting Single-Area OSPFv2

 

Submit QB5.pka.

 

Submit  the  “Documentation  Table”B5.pdf  as  Q

 

Question B6 - 3_6.2.3 Packet Tracer - Configuring Multiarea OSPFv2

 

Submit QB6.pka.

 

Question B7 - 3_6.2.3 Packet Tracer - Configuring Multiarea OSPFv3

 

Submit QB7.pka.

 

Question B8 - 3_7.2.2 Packet Tracer - Configuring Basic EIGRP with IPv4 Submit QB8.pka.

 

Submit answers to the questions as QB8.pdf.

 

Question B9 - 3_7.4.3 Packet Tracer - Configuring Basic EIGRP with IPv6 Routing

 

Submit QB9.pka.

 

Question B10 - 3_8.1.2 Packet Tracer - Configuring EIGRP Manual Summary Routes for IPv4 and IPv6

Price: £109

100% Plagiarism Free & Custom Written - Tailored to Your Instructions